Mixers, Frequency Converters & Modulators
Agilent offers various software tools for design, synthesis, and simulation of mixers, frequency converters and modulators. Agilent's Advanced Design System (ADS) and Genesys EDA tools include multiple examples, templates and DesignGuides that enable you to quickly get started with your mixer design projects.
One you have designed your mixer and built a prototype, Agilent offers a wealth of test and measurement equipment that can help you measure and validate your design.
Refine the List
remove all refinementsBy Type of Content
- Document Library
-
Application Notes
- Application Note
-
Application Notes
By Product Category
-
All Product Categories
- Oscilloscopes, Analyzers, Meters
1-12 of 12
|
8753 Mixer Measurements (PN 8753-2)
This Product Note describes several procedures and hardware setups for measuring the performance of a mixer or frequency translator
using the Agilent 8753B Vector Network Analyzer.
Application Note 2000-11-01 |
PDF
3.49 MB
|
|
Accurate Mixer / Amplifier Compression Measurement using the 8901A Modulation Analyzer (AN 286-2)
This Application Note is for information only. Agilent no longer sells or supports these products.
Application Note 1981-04-01 |
PDF
1.43 MB
|
|
Accurate Mixer Measurements with ENA Frequency-Offset Mode (AN 1463-6)
Recommended measurement procedures for evaluating mixers.
Application Note 2007-05-07 |
|
|
ENA/PNA - Mixers - Calibration Accuracy using FCA (1408-3)
Improving Measurement and Calibration Accuracy Using the Frequency Converter Application - AN 1408-3
Application Note 2006-08-08 |
|
|
ENA/PNA - Mixers - Comparing Mixer Measurement Techniques (1408-2)
This paper compares techniques and instruments for measuring conversion loss and group delay on a single stage converter with an embedded low pass filter. Conversion loss using a: spectrum, scalar, and vector network analyzer.
Application Note 2004-01-28 |
PDF
265 KB
|
|
ENA/PNA - Mixers - New Vector Characterization Techniques
This paper presents a novel method for characterizing RF mixers, yielding magnitude, phase, and group delay response of the conversion loss, as well as the input match and output match.
Application Note 2002-10-04 |
|
|
ENA/PNA - Mixers - Transmission Measurements using FCA (1408-1)
Microwave PNA Series Network Analyzer Application Note, mixer transmission measurements using the frequency converter application note 1408-1
Application Note 2003-05-16 |
|
|
ENA/PNA - Mixers - Vector Error Correction
A method for characterizing RF mixers, yielding magnitude and phase response for input match, output match,conversion loss, and mixers which have reciprocal conversion loss and for which the image response can be filtered out.
Application Note 2003-11-11 |
|
|
Impedance and Network Analysis Application List Application Note
This document provides the information of unique and new solutions for impedance and network analysis with using Agilent impedance analyzers, LCR meters and ENA series network analyzers.
Application Note 2012-10-30 |
PDF
1.11 MB
|
|
Network Analysis - Mixers - Characterize Frequency-Translating Devices (AN 1287-7)
This Application Note explores current test equipment solutions and techniques that can be used to accurately characterize and test frequency-translating devices.
Application Note 2000-03-01 |
PDF
529 KB
|
|
PNA - Mixers - Absolute Group Delay of Multistage Converters
This paper describes new calibration and measurement techniques for measuring absolute group delay of frequency converters with multiple mixing stages
Application Note 2003-11-24 |
PDF
505 KB
|
|
PNA - Mixers - Advances in Converter Test
Agilent 2005 Aerospace Defense Symposium presentation
Application Note 2006-04-24 |
PDF
2.12 MB
|
Enroll in myAgilent
Register Your Product
Why Buy Agilent