Contact an Expert

Application Information About Specific Components & Devices

1-25 of 25

Sort:
Accurate Mixer Measurements with ENA Frequency-Offset Mode (AN 1463-6) 
Recommended measurement procedures for evaluating mixers.

Application Note 2007-05-07

Automated Measurement with IC-CAP 
This application note describes a seamless solution for automated measurement and parameter extraction with Agilent IC-CAP

Application Note 2011-01-10

Creating Measurement-Based Amplifier Behavioral Models 
This Application Note describes a behavioral model used in circuit and system simulations to verify performance of the amplifier within a circuit or system.

Application Note 2003-10-01

Design and Measurement of a 400 MHz Frequency Synthesizer: Accuracy Proof 
This Application Note explains the 400 MHz PLL design with examples and hence giving the engineer a powerful effective tool for designing real PLLs.

Application Note 2001-11-01

Design of a 4.9 to 6.0 GHz Two-Stage Low Noise using ATF-551M4 E-PHEMT 
This Application Note examines the design of a compact two-stage, low noise, unconditionally stable, amplifier for 802.11a, HiperLAN2 and HiSWANa receiver applications using ATF-551M4 E-PHEMT.

Application Note 2005-02-01

PDF PDF 245 KB
ENA/PNA - Mixers - New Vector Characterization Techniques 
This paper presents a novel method for characterizing RF mixers, yielding magnitude, phase, and group delay response of the conversion loss, as well as the input match and output match.

Application Note 2002-10-04

ENA/PNA - Mixers - Vector Error Correction 
A method for characterizing RF mixers, yielding magnitude and phase response for input match, output match,conversion loss, and mixers which have reciprocal conversion loss and for which the image response can be filtered out.

Application Note 2003-11-11

Genesys S/Filter Software Directly Synthesizes Filters with Arbitrary Transmission Zero Placement 
This white paper describes direct filter synthesis capabilities in Agilent Genesys S/Filter design software used to realize custom filter response.

Application Note 2011-01-12

High IP3 Mixers for Cellular Applications  
An Application Note focusing on Hittite high IP3 mixer for cellular applications.

Application Note 2004-05-25

PDF PDF 344 KB
IFT Battery Current Drain Solution  
Provides an overview of the Interactive Functional Test (IFT) battery current drain analysis solution using the 8960 (E5515C) and the 66319/21B or D.

Application Note 2008-09-30

Linearization of Multi-Carrier Power Amplifier via Digital Predistortion in ADS 
This Application Bulletin describes a method for using digital predistortion in Advanced Design System with the Linearization Design Guide to minimize spectral regrowth in wireless systems.

Application Note 2009-03-19

Making Conducted and Radiated Emissions Measurements 
This application note provides an overview of radiated and conducted emissions measurements as well as a methodology for EMI precompliance testing.

Application Note 2010-07-13

Network Analysis - Filter And Amplifier Measurement Examples (AN 1287-4) 
The network analyzer is used for a variety of device and component characterization tasks in both laboratory and production environments.

Application Note 2000-08-01

Network Analysis - Mixers - Characterize Frequency-Translating Devices (AN 1287-7) 
This Application Note explores current test equipment solutions and techniques that can be used to accurately characterize and test frequency-translating devices.

Application Note 2000-03-01

Optimizing Power Savings on WiMax and Other Cellular WWAN Interface Devices 
This document describes how to optimze power savings on WiMax and other cellular WWAN interface devices.

Application Note 2008-07-15

Phased Locked Loop Acquisition Using a Swept Local Oscillator 
This Application Note details the Phased Locked Loop Acquisition Using a Swept Local Oscillator.

Application Note 2000-03-02

PLL’s using a Charge Pump, High Divide-by-N Factors, and Decimation before Plotting 
This Application Note shows an approach for designing a phase locked loop (PLL) that uses a charge pump, High Divide-by-N Factors, and Decimation before Plotting.

Application Note 2001-03-20

PNA - Antenna - Pulsed Measurements 
This paper presents advances in the instrumentation techniques that can be used for the measurement and characterization of antennas that are to be tested in a pulsed mode of operation.

Application Note 2004-01-06

PNA - Mixers - Absolute Group Delay of Multistage Converters 
This paper describes new calibration and measurement techniques for measuring absolute group delay of frequency converters with multiple mixing stages

Application Note 2003-11-24

PNA - Mixers - Advances in Converter Test 
Agilent 2005 Aerospace Defense Symposium presentation

Application Note 2006-04-24

PDF PDF 2.12 MB
Practical RF Amp. Design Using the Available Gain Procedure & the ADS EM/Circuit Co-Sim. Capability 
This white paper features a method of designing a low noise RF amplifier for an 802.11b receiver application and contains an Avago ATF54143 PHEMT transistor.

Application Note 2009-06-25

RF Mixer Metasystem Behavioral Model 
This Application Note describes the behavioral model of RF Mixer Metasystem.

Application Note 1997-04-03

PDF PDF 197 KB
Simulating Envelope Tracking with Advanced Design System 
This example applies envelope tracking to an example amplifier to show techniques of using Advanced Design System (ADS) for this type of design.

Application Note 2012-11-22

PDF PDF 2.30 MB
Small Engine Dynamometer Testing 
Performing Dynamometer Testing on Combustion Engines

Application Note 2008-06-01

PDF PDF 443 KB
The 2001 CAD Benchmark Rat-Race Mixer Characterisation 
This AN highlights the benchmark specifications submitted to CAD vendors by Microwave Engineering Europe Magazine and also details Eagleware’s submitted simulations to Microwave Engineering Europe.

Application Note 2001-10-01

PDF PDF 478 KB