PCIe™ 3.0 Receiver Testing: How to Generate the Test Set-up and Calibrate the Stressed Eye
Webcast - recorded | Where & When
Why this presentation is important:
By the end of this year PCI Express® rev. 3 will be released.
Doubling effective data rate vs rev. 2 without increasing the transfer rate by a factor of two resulted in quite a few changes on the phy layer. These changes and their consequences will be addressed at the beginning of the Webcast.
As this higher transfer rate is mainly achieved by a more sophisticated receiver (RX) with complex equalization, its testing is now normative and no more informative as before. Therefore, this Webcast will focus on RX testing, the specified test set-ups and the calibration of the test signals.
As the latter is very different from what was done before, a good part of the Webcast will describe this procedure.
In the end an outlook will be given upon what to expect from the upcoming CEM-specification as far as it is stable yet.
Who should attend:
R&D and Design Verification Engineers doing physical layer test and/or characterization on receivers of PCIe3 ports of ASICS and PCIe3 add-in-cards and motherboards.
PCIe is a trademark of the PCI-SIG
PCI EXPRESS is a registered trademark of the PCI -SIG
Where & When
|Price||Location||For more information|
|Free||At Your PC||View the recording of the live broadcast on Oct 12, 2010|
Prices shown are list prices and are subject to change without notice.
Enroll in myAgilent
A personalized view into the information most relevant to you.
Register Your Product
Register your products for service notifications, firmware update alerts, application notes and more…
Why Buy Agilent
See how the Agilent Advantage adds value to your purchase.
Learn about Keysight
Agilent’s Electronic Measurement Group is becoming Keysight Technologies.