Technical Support

Test et mesure électronique

Caution: MIMO Test Challenges Ahead Article published by Wireless Design & Development on MIMO testing challenges and methods to achieve higher data rates such as two0 and four-channel MIMO. Article 2010-09-20	PDF 70 KB
The Fifth Harmonic: Tradeoffs Between Sampling and Real-Time Oscilloscopes When determining the required system bandwidth some vendors will use a “fifth harmonic” rule of thumb; however it is important to understand typical conditions at the receiver to accurately determine the amount of bandwidth you will need. Article 2009-01-19
Validating the Physical and Protocol Layers in DDR Memory Interfaces Article 2009-01-06
Eye-Diagram Analysis Speeds DDR SDRAM Validation Article 2009-01-06
Is the 5th Harmonic Still Useful for Predicting Data Signal Bandwidth? This article, published in High Frequency Electronics, compares using the 5th harmonic to using the system rise/fall times to determine the required bandwidth for your system. The article begins on page 18. Article 2009-01-01
Simplify DDR Validation with SI Methods Article 2008-01-06
Testing HSUPA devices By: Jeanne Fightmaster, Agilent Technologies Published with permissions of EETimes Asia Article 2007-11-16	PDF 404 KB

Enroll in myAgilent
A personalized view into the information most relevant to you.
Register Your Product
Register your products for service notifications, firmware update alerts, application notes and more…
Why Buy Agilent
See how the Agilent Advantage adds value to your purchase.