Technical Support
Test et mesure électronique
Refine the List
retirer tout le raffinementPar application
By Type of Content
- Document Library
- Application Notes
- Application Note (144)
- Analysis Tool (1)
Par catégorie de produit
-
Toutes les catégories de produit
-
Generators, Sources, Supplies
- Signal Generators (Signal Sources)
-
Generators, Sources, Supplies
- Application Notes
76-100 of 145
|
Using LAN in Test Systems - Network Configuration (AN 1465-10) - Application Note
The decision to use LAN in a test system delivers important benefits to your company and your team.
From a business perspective, intense competition among equipment vendors has produced a wide selection of high quality, low-cost solutions for local area networking
Application Note 2004-09-14 |
PDF
182 KB
|
|
Using LAN in Test Systems - The Basics (AN 1465-9) - Application Note
The basic purpose of any test system is to characterize and validate the performance of electronic components, assemblies or products. The complexity of this task depends on variables such as the physical nature of the device under test (DUT), the number of tests to be performed, the number of signals to be measured and the desired time per test.
Application Note 2004-07-29 |
PDF
270 KB
|
|
Performing Digital-IF/RF-Digital Bit Error Rate Measurement
This AN describes how to use Agilent Instruments and ADS EDA software to verify RF performance measures such as BER and EVM for end-to-end digital-IF/RF-digital systems--from bits in to bits out.
Application Note 2004-03-12 |
PDF
270 KB
|
|
Radar Emitter Simulation Using the E8267C PSG Vector Signal Generator
This 32-page application note explains how to generate and evaluate complex radar signals using the Agilent E8267C vector signal generator.
Application Note 2003-12-01 |
|
|
Radar Emitter Simulation Using Vector Signal Generators (MATLAB waveform examples)
Example of MATLAB files for generating complex waveforms (at ease) for radar system design verification using off-the-shelf microwave vector signal generators.
Analysis Tool 2003-11-12 |
ZIP
12 KB
|
|
E4438C Signal Studio for Bluetooth® Application Note (AN 1421)
This application note is a self-guided tutorial that describes the test signals that can be created with Signal Studio for Bluetooth®.
Application Note 2003-10-16 |
PDF
1.37 MB
|
|
E4438C Signal Studio for 1xEV-DO Application Note
This application note is a self-guided tutorial describing the test signals that can be created with Signal Studio for 1xEV-DO.
Application Note 2003-06-13 |
PDF
2.37 MB
|
|
Designing and Testing cdma2000 Base Stations (AN 1357)
This Application Note describes base station design and measurement issues at the physical...
Application Note 2003-02-25 |
|
|
Designing and Testing 3GPP W-CDMA User Equipment - Application Note
This Application Note focuses on the physical layer (layer 1) of the Frequency Division Duplex (FDD) mode of W-CDMA.
Application Note 2003-02-21 |
|
|
Making 802.11G Transmitter Measurements (AN 1380-4)
This 12-page application note provides an overview of 802.11g WLAN technology and reviews the tests used to design and manufacture 802.11g transmitters and modulators.
Application Note 2003-02-21 |
|
|
Two-tone and Multitone Personalities for the E8267C PSG Vector Signal Generator (AN 1410)
Generating two-tone and multitone signals at MW frequencies has never been easier. The E8267C PSG is the first MW signal generator with an integrated I/Q modulator and internal baseband generator.
Application Note 2003-02-06 |
PDF
790 KB
|
|
Obtain Flat-Port Power with Agilent's PSG User Flatness Correction or External Leveling Functions
The PSG series is ideally suited for design and test systems with high frequencies, wide bandwidths and complex modulation formats. This Product Note explains how to obtain flat...
Application Note 2003-02-04 |
PDF
2.22 MB
|
|
Designing and Testing cdma2000 Mobile Stations - Application Note 1358
One of the proposals for the IMT-2000 requirements for a 3G global wireless communications system is cdma2000. This application note describes mobile station design and measurement issues at the physical layer (layer 1) that may be different between cdma2000 and cdmaOne.
Application Note 2003-01-13 |
|
|
E443xB Signal Studio for 802.11a WLAN Application Note (AN 1430)
This application note is a self-guided tutorial that describes the test signals that can be created with Signal Studio for 802.11a WLAN.
Application Note 2002-10-16 |
PDF
1.31 MB
|
|
E443xB Signal Studio for Bluetooth® Application Note (AN 1422)
This application note is a self-guided tutorial that describes the test signals that can be created with Signal Studio for Bluetooth®.
Application Note 2002-10-03 |
PDF
1.95 MB
|
|
Understanding GSM/EDGE Transmitter and Receiver Measurements for Base Transceiver Stations (AN 1312)
This 36-page application note presents the fundamental RF parametric measurements necessary to characterize GSM/EDGE base transceiver stations and their components.
Application Note 2002-08-24 |
|
|
E4438C Signal Studio for 802.11a WLAN Application Note
This application note is a self-guided tutorial describing the test signals that can be created with Signal Studio for 802.11a WLAN.
Application Note 2002-03-27 |
PDF
2.31 MB
|
|
E4438C ESG Vector Signal Generator Differential I/Q outputs
This note provides a brief description of baseband I/Q signals, I/Q adjustments on the ESG, and a demonstration of the menu placement of each of the adjustments, as well as their physical function.
Application Note 2002-03-27 |
PDF
1.92 MB
|
|
Testing and Troubleshooting Digital RF Communications Receiver Designs (AN 1314)
This Application Note covers the fundamental measurement principles involved in testing and troubleshooting digital communications
receivers, particularly those used in digital RF cellular systems. Measurement setups are provided for receiver performance tests and
troubleshooting tips are given.
Application Note 2002-03-25 |
|
|
E4438C Signal Studio for 802.11b WLAN Application Note
This application note is a self-guided tutorial describing the test signals that can be created with Signal Studio for 802.11b WLAN.
Application Note 2002-03-15 |
PDF
1.56 MB
|
|
E443xB Signal Studio for 1xEV-DO Product Overview
This 2-page product overview contains the main features, benefits, and ordering information for Option 404 for the E443xB.
Application Note 2002-01-31 |
PDF
187 KB
|
|
E443xB Signal Studio for 1xEV-DO Application Note
This application note is a self-guided tutorial describing the test signals that can be created with Signal Studio for 1xEV-DO.
Application Note 2002-01-31 |
PDF
1.69 MB
|
|
Testing and Troubleshooting Digital RF Communications Transmitter Designs (AN 1313)
This Application Note covers the following 3 topics: 1) How digital communications transmitters work, 2) Essential transmitter tests and important test equipment characteristics, and 3) Troubleshooting techniques for common impairments.
Application Note 2002-01-08 |
PDF
957 KB
|
|
8 Hints for Making Better Measurements Using Analog RF Signal Generators
This guide helps you improve the accuracy of your measurements that involve using RF analog signal sources.
Application Note 2001-11-14 |
|
|
Communications Agile Operation of the 8645A (PN 8645-1)
This product note for the 8645A signal generator includes topics such as: channels and sequences, rate and dwell, frequency hop modes, timing control and synchronization, and amplitude control.
Application Note 2001-11-13 |
PDF
831 KB
|
Enroll in myAgilent
Register Your Product
Why Buy Agilent