Contact an Expert

Technical Support

EMI/EMC, Phase Noise, Physical Layer Test Systems

Find by Product Model Number: Examples: 34401A, E4440A

1-15 of 15

Signal & Spectrum Analyzer Benchtop/Handheld Firmware Update Center
To access the most recent version of firmware or software for signal and spectrum analyzer - benchtop and handheld models.

FAQ 2014-03-10

Where can I find manuals for discontinued and obsolete Hewlett-Packard and Agilent test equipment?
Most Agilent products have PDF manuals that can be found on product pages. Other vendors also supply old manuals.

FAQ 2013-11-22

I lost my Agilent E5500 Phase Noise System license key. How do I obtain a permanent replacement license key?
In order to obtain a permanent replacement phase noise system license key the phase detector test set (70420A or N5500A) serial number is required.

FAQ 2012-10-31

Which high impedance / differential probe can be used with the E5052A/B Signal Source Analyzer?
The 54006A 6 GHz Passive Divider Probe Kit, the 41800A Active Probe, U1818A/B Active Differential Probe, the 1134A InfiniimMax 7 GHz Probe, can be used with the E5052A/B Signal Source Analyzer.

FAQ 2011-05-24

When should I press "Discharge DC Block Capacitor" softkey of the E5052B?
It is recommended to press this softkey when reconnecting the DUT at the baseband input port of the E5052B.

FAQ 2008-10-22

Where can I find the E5052A/B and E5053A phase noise calculator?

FAQ 2008-08-28

Can I change the regional setting of Windows system running in the E5052B?
No, the default setting is "English (United States)" and the E5052B can not support the other setting.

FAQ 2008-07-18

How often should we perform the verification procedure described in the Performance Tests section of the manual?
Every 12 months.

FAQ 2008-01-11

Why the I/O library cannot read data from the instrument?
A suggested procedure for the IO Libraries Error Message.

FAQ 2008-01-08

How do I troubleshoot E5500 GPIB connectivity?
Here is the procedure to follow if there is a problem with instrument connections via GPIB with the E5500 software.

FAQ 2007-10-18

Is there a master listing of compatible printers for various network analyzers and impedance analyzers?

FAQ 2007-07-10

How can I store the measurement data in the storage device (i.e. built-in HDD) via SCPI command?
You can use :MMEMory command to store the trace or memory data of the display.

FAQ 2007-04-22

Performance Test

FAQ 2003-05-21

What does the instrument's rear panel look like?

FAQ 2002-06-27

What procedures should be followed when operating the PSG series SigGen with the 4352S?

FAQ 2002-06-27