Contact an Expert

Technical Support

Test & Measurement

Find by Product Model Number: Examples: 34401A, E4440A

Refine the List

remove all refinements

By Topic

By Type of Content

By Product Category

1-9 of 9

Sort:
Do you have an example C# code to control the N4960A BERT?
Yes.

FAQ 2013-05-06

8614xA/B Optical Spectrum Analyzer Firmware
Firmware revisions are made to add enhancements and to fix defects. We recommend that you use the latest version of firmware available.

FAQ 2013-03-20

UNH-IOL JBISTGUI Software
JBISTGUI utilizes the two channel mode of J-BERT N4903B and configures transmission of the necessary pattern sequences that can enable the BIST-L and BIST-TAS test modes for SATA host and device products. This Software simplifies Agilent’s receiver test setup by eliminating the need to switch between a protocol tester and J-BERT.

FAQ 2013-03-18

How much the default RF port power of N4375B? And can I change it?
It is 0 dBm, and you can change it.

FAQ 2012-03-01

PDF PDF 46 KB
Serial BERT Software
Find all the latest software and firmware for the Serial BERT including: N4902B, N4906A, N4906B, and N4917A.

FAQ 2010-06-24

Is it possible to save multiple TDR traces and display them as waveforms on the oscilloscope for comparison to my current measurement?
It is possible to save multiple TDR traces as an internal format for future reference...

FAQ 2008-07-07

Can measurements be made on the saved waveforms?

FAQ 2008-07-07

Is it possible to save a previous TDR measurement waveform and load as a comparison for my current TDR measurement?
It is possible to save a previous TDR measurement waveform and load it onto the oscilloscope as a comparison to the current measurement.

FAQ 2008-07-07

Can I install the Infiniium Help system on my PC?
Yes. You may download the Help file for your model of Infiniium and install it on your PC’s hard drive for easy access.

FAQ 2007-01-10