Contact an Expert

Technical Support

Test & Measurement

Refine the List

remove all refinements

By Topic

All Topics
- Calibration

By Type of Content

FAQ (12)

By Product Category

All Product Categories
- Oscilloscopes, Analyzers, Meters
  - LCR Meters & Impedance Measurement Products
    - Impedance Analyzers

1-12 of 12

What is the difference between an "ECal Confidence Check" and a Network Analyzer "System Verification" test? The ECal Confidence Check is a method to check the accuracy of a calibration performed with either a mechanical cal kit or an ECal module. System verification testing provides network analyzer users a method to verify that the network analyzer is ... FAQ 2012-10-17
Does the ENA 6 series support User Characterized Ecal? No. FAQ 2012-09-25
What mechanical calibration kits and Ecal (electronic calibration) kits does the ENA support? Please refer to following documents... FAQ 2012-09-25
Does the ENA allow user access to the Error Coefficient Arrays? FAQ 2012-03-16
How is trace math implemented within the Agilent Technologies Vector Network Analyzers? FAQ 2012-01-11
After performing a calibration with a user defined calibration kit, all log magnitude data is displayed as -200 dB; why? FAQ 2011-10-07
Is there an error in the delay/thru definition for the 85039B F-Type Calibration Kit? Yes. FAQ 2011-10-07
How should I define or select the residual inductance values of Shorting Bars when performing Short compensation on the E4991A or the 4287A? Nowadays, the authorized standards stipulate the dimensions of shorting devices and the Short Compensation method which uses the defined inductance values of the shorting devices. It is recommended to consider these authorized standards. FAQ 2010-07-02
Why does measurement data exhibit a discontinuity at 5 MHz or 15 MHz and how can the 4294A get rid of this phenomenon? The 4294A extends its measurement frequency range up to 110 MHz by terminating each measurement terminal with 50 ohm in order to eliminate the resonance of test leads (including leads inside the 4294A). FAQ 2010-07-02
Can the 4395A/4396B read the cal data from the disk that comes with the cal kits such as the 85033D, 85039A, 85039B, etc? No, the 4395A/4396B can't read the cal data from the disk furnished with these cal kits. FAQ 2008-11-18
How should I set the "Adapter Setting" of the 4294A when using the 16089A/B/C/D/E? Please set to "NONE". FAQ 2008-10-07
What are the default calibration kit selections on the 4395A and 4396B Combination Analyzers? FAQ 2007-03-13

Enroll in myAgilent
A personalized view into the information most relevant to you.
Register Your Product
Register your products for service notifications, firmware update alerts, application notes and more…
Why Buy Agilent
See how the Agilent Advantage adds value to your purchase.