Hable con un experto

Technical Support

Test y Medida

Refine the List

remove all refinements

By Topic

All Topics
- Display Messages/Error Codes

By Type of Content

FAQs
- FAQ

By Product Category

All Product Categories
- Oscilloscopes, Analyzers, Meters
  - EMI/EMC, Phase Noise, Physical Layer Test Systems
    - EMI Receivers and EMC Precompliance Analyzers (9)

1-10 of 10

How often does the system user alignment for the PSA EMI Measurement Receiver need to be run? 30 days or 3° C temperature change. See contents for details... FAQ 2012-12-11
Why do I get a Meas Uncal message when I select either the Quasi-Peak or EMI Average detector for taking a full band sweep with the MXE EMI Receiver? Sweeptime has reached its maximum. See complete FAQ for further details... FAQ 2012-05-10
Why do I get the "Align 20 Hz to 3.6 GHz Required" message every time I turn my MXE on? You don't. Wait for it to warm back up... FAQ 2012-05-09
Why do I continue to get the "Align 20 Hz to 3.6 GHz Required" message even though I ran the Align Now, All routine on my MXE? You also need to run the System, Alignments, More, RF Preselector, Align Now alignments... FAQ 2012-05-09
How long does the system user alignment of my PSA EMI Measurement Receiver take to run? A full system alignment takes approx. 30 minutes. See FAQ content for further details... FAQ 2012-03-16
What does the system user alignment of my PSA EMI Measurement Receiver do? See contents for details... FAQ 2012-03-16
Why does my PSA EMI Measurement Receiver tell me that I need to run the user alignment everyday? There are a couple of reason why this could be hapening. See FAQ contents for details... FAQ 2012-03-16
What should I do if the system user alignment of my PSA EMI Measurement Receiver fails? This could be caused by a few different reasons. See contents for details... FAQ 2012-03-16
What is the frequency range of the N5532A Sensor Module? 100 kHz to 4.2 GHz, 10 MHz to 18 GHz, 30 MHz to 26.5 GHz, and 30 MHz to 50 GHz. FAQ 2012-02-26
Is it possible to get an error log of incorrectly sent remote commands to my PSA, E4406A, EMC, or ESA Series Spectrum Analyzer? Yes. PSA, E4406A and the ESA Series (with firmware A.08.00 and later) support this. You may turn Verbose error logging on through the front panel or remotely, SYST:ERR:VERBOSE ON FAQ 2008-11-21

Enroll in myAgilent
A personalized view into the information most relevant to you.
Register Your Product
Register your products for service notifications, firmware update alerts, application notes and more…
Why Buy Agilent
See how the Agilent Advantage adds value to your purchase.