Technical Support

Test & Measurement

Why do we see unused port in U2300A/U2500A with similar waveform and frequency but with lower amplitude to its adjacent or close by used port? It is recommended to ground all the AI connection that is not being used. If you have multiples of AI channels to be used, one good way is to have… FAQ 2010-08-09
Why is my acquired data for U2300A and U2500A shifted? eg. Column 2 data is in column 1, column 3 data is in column 2, and so on. Install DAQ hardware driver version 1.05 and above. FAQ 2010-08-09
When I sent commands using VISA (Both Agilent VISA and NI VISA), why must i put '\n' or '\r' after the commands for U2600A… Please upgrade your U2600A firmware to version 1.05 or above FAQ 2010-08-09
Why USB modular instruments (U272XA, U2741A, U2751A and U2761A) is not detectable by E5813A? PC is failed to enumerate the USB modular instrument. FAQ 2010-04-09
Why do I receive an error message below ? Generally, if you are sampling at 60kSa/s and above, you should use high sampling mode to acquire data. This is just a rough guideline. If you encountered this message even when.... FAQ 2009-08-06

Enroll in myAgilent
A personalized view into the information most relevant to you.
Register Your Product
Register your products for service notifications, firmware update alerts, application notes and more…
Why Buy Agilent
See how the Agilent Advantage adds value to your purchase.