|
|
|
RS-232 를 통해서 53131/32A 혹은 53181A 카운터로 통신을 하려면 어떻게 해야 합니까?
|
2003-07-22
|
FAQ
|
|
|
|
|
생산 중단되었거나 폐기된 HP 및 애질런트 테스트 장비 매뉴얼은 어디서 구할 수 있습니까?
매뉴얼을 다양한 방법으로 검색 또는 요청하실 수 있습니다.
|
2006-08-15
|
FAQ
|
|
|
|
|
애질런트 테스트 및 측정 제품용 계측기 드라이버는 어떻게 구할 수 있습니까?
계측기 드라이버 링크가 계측기 기술 지원 웹 사이트 페이지에 있습니다.
|
2008-12-29
|
FAQ
|
|
|
|
|
전원을 끈 후에도 카운터의 팬이 여전히 작동하는 이유는 무엇입니까?
타임베이스로의 전원이 그대로 유지되면 팬은 켜진 상태이기 때문입니다.
|
2006-12-13
|
FAQ
|
|
|
|
|
53181A/31A/32A: Can options be retrofitted on the 53131A/53132A/53181A counters?
This table explains which options may be installed and/or require a service center.
|
2009-02-25
|
FAQ
|
|
|
|
|
Are the Agilent 53131A, 53132A, and 53181A inputs floating or grounded?
The counter inputs are not floating -- the BNC shield (shell) is at chassis ground (earth ground).
|
2002-09-09
|
FAQ
|
|
|
|
|
Does the frequency counter come standard with a 10MHz external time base option?
Yes. A standard time base is provided that can be routed to other instruments for synchronization. You may also supply your own external time base as an input to the frequency counter.
|
2009-03-13
|
FAQ
|
|
|
|
|
How do I rack mount two instruments of different depths?
There are three ways to rack instruments of different depths side-by-side; for example, an Agilent 33220A with an Agilent 34401A.
|
2007-01-29
|
FAQ
|
|
|
|
|
How do you know when the counter has completed a measurement?
One of three methods: reading the register, reading the Status Byte or generating an interrupt.
|
2008-03-17
|
FAQ
|
|
|
|
|
How do you prevent the counter from hanging up the GPIB bus when no signal is applied?
Set the GPIB timeout value to a sufficient value to complete the measurement.
|
2008-03-17
|
FAQ
|
|
|
|
|
What are the hysteresis band values for the Agilent 531xxA-Series Counters?
Some of the counter accuracy formulas (see the manual's specifications section) ask for hysteresis band information.
|
2005-12-15
|
FAQ
|
|
|
|
|
Why do the specifications for counter time interval measurements list a negative time value for the range?
The counter will display a negative result if the end on the 2nd channel slightly precedes the edge on the first channel.
|
2008-05-12
|
FAQ
|
|
