|
|
|
How can I connect a test fixture to the measurement terminals of the E4980A when the stopper (dual plastic bars) at the rear of the fixture disturbs the connection?
Remove the stopper from the test fixture by removing a screw at the center of the plastic stopper. Otherwise, remove the front rubber guide from the E4980A.
|
2009-03-11
|
FAQ
|
|
|
|
|
How can I order supplemental parts for component test fixtures/accessories?
You can order the necessary parts by the part numbers shown in the Accessories Selection Guide for Impedance Measurements.
|
2008-04-22
|
FAQ
|
|
|
|
|
How do I get Instrument Drivers for Agilent Test & Measurement Products?
From the CD shipped with the instrument or from the product technical support web page for the instrument.
|
2009-05-01
|
FAQ
|
|
|
|
|
What are significant error sources when a thin film material is measured with the 16451B?
Small air gaps become primary error source for the permittivity measurement of thin materials.
|
2008-05-20
|
FAQ
|
|
|
|
|
What are the frequency limitations on the various probes utilized with the Agilent 85070E Dielectric Probe Kit and why?
The 85070E Dielectric Probe options 020, 030 and 050 have maximum frequeny via the E4991A Impedance Analyzer of 3 GHz.
|
2009-05-28
|
FAQ
|
|
|
|
|
What resources does Agilent recommend to help facilitate learning proper impedance measurement techniques?
|
2008-01-14
|
FAQ
|
|
|
|
|
Where can I find manuals for discontinued and obsolete Hewlett-Packard and Agilent test equipment?
Most Agilent products have PDF manuals that can be found on product pages. Other vendors also supply old manuals.
|
2009-11-04
|
FAQ
|
|
|
|
|
Why is it recommended to pre-form electrodes on both sides of thin film materials measured with the 16451B?
Pre-forming electrodes on both sides of film materials can minimize measurement errors due to air gaps between 16451B's electrodes and the material.
|
2008-05-20
|
FAQ
|
|
|
|
|
Would you give me the information on part number changes for the mechanical parts?
Please refer to the following table.
|
2008-06-29
|
FAQ
|
|
