1156A Active Probe, 1.5 GHz
|Product Status:||Discontinued | Currently Supported|
|Supported Until:||1 September 2016|
A replacement for this product is available:
Key Features & Specifications
- 1.5 GHz
- DC Offset Range: +/- 15V
- Dynamic Range: 5V peak-to-peak
- For waveforms with edges >3nsec, dynamic range is >12Vpp.
- Input R: 100 kOhm
- Input C: 0.8 pF
- AutoProbe interface compatible
The Agilent 1156A, 1157A, and 1158A family of active probes offers R & D engineers the performance they need to probe small geometries in hard-to-reach areas on the DUT. These probes were designed specifically for the Infiniium Series, and InfiniiVision 5000, 6000 and 7000 Series 300 MHz - 1 GHz oscilloscopes.
As the speeds in your design increase, you may notice more overshoot, ringing, and other perturbations when connecting an oscilloscope probe. Probes form a resonant circuit where they connect to the device. If this resonance is within the bandwidth of the oscilloscope probe you are using, it will be difficult to determine if the measurement perturbations are due to your circuit or the probe.
Agilent is the only company that has overcome the resonance formed by the connection of a probe to a device. The Agilent 1156/7/8A probes optimize performance to make your job easier.
Notice: The Agilent 1156A was discontinued June 1, 2011. End of support life for this product is Sept. 1, 2016.
The N2795/96A active probe is the recommended replacement probe for the InfiniiVision 3000 X-, 4000 X-, 5000, 6000, 7000, and Infiniium 9000 and 90000 Series oscilloscopes.
The 1157A/58A active probe is the recommended replacement probe for the Infiniium 548xx, 8000 and 80000 Series oscilloscopes.