Thread: How to add .s2p file to the inductor properties.

Reply to this Thread Reply to this Thread Search Forum Search Forum Back to Thread List Back to Thread List

Permlink Replies: 1 - Pages: 1 - Last Post: May 5, 2012 7:15 PM Last Post By: mingal
channing

Posts: 2
Registered: 05/05/12
How to add .s2p file to the inductor properties.
Posted: May 5, 2012 7:27 AM
genesys
Click to report abuse...   Click to reply to this thread Reply
If i want to add my own .s2p fille to the inductor model, how to do this, just like the library of “Coil Craft ” which inductor properties contains the .s2p files. THX.!
mingal

Posts: 108
Registered: 06/08/09
Re: How to add .s2p file to the inductor properties.
Posted: May 5, 2012 7:15 PM   in response to: channing in response to: channing
Click to report abuse...   Click to reply to this thread Reply
Dear channing-

When you double-click the coil you will get a dialog box Where it says, "Model:" You can choose to use a data file. There is a pretty good description in Help. just look up "Inductor Part" in Home > Part Catalog > Eagleware Library Part Categories > Inductors Category...

OK?

Mark
www
Pages: 1
Back to Thread List Back to Thread List

Point your RSS reader here for a feed of the latest messages in all forums