Thread: How to add .s2p file to the inductor properties.


Permlink Replies: 1 - Pages: 1 - Last Post: May 5, 2012 7:15 PM Last Post By: mingal
channing

Posts: 2
Registered: 05/05/12
How to add .s2p file to the inductor properties.
Posted: May 5, 2012 7:27 AM
Click to report abuse...   Click to reply to this thread Reply
If i want to add my own .s2p fille to the inductor model, how to do this, just like the library of “Coil Craft ” which inductor properties contains the .s2p files. THX.!
mingal

Posts: 108
Registered: 06/08/09
Re: How to add .s2p file to the inductor properties.
Posted: May 5, 2012 7:15 PM   in response to: channing in response to: channing
Click to report abuse...   Click to reply to this thread Reply
Dear channing-

When you double-click the coil you will get a dialog box Where it says, "Model:" You can choose to use a data file. There is a pretty good description in Help. just look up "Inductor Part" in Home > Part Catalog > Eagleware Library Part Categories > Inductors Category...

OK?

Mark
www

Point your RSS reader here for a feed of the latest messages in all forums