I want to insert pulsed signal to the DC connector of the Agilent 11612V K61 or K62 bias tee. Which voltage values to which pins in LEMO connector ( 6 pins) should I apply in order to switch the bias tee into pulse mode?
normally, these bias tees were controlled directly by a bias pulser in a system. I don't have a wiring diagram of the round LEMO control connector. But, the manual does have the control logic for various modes. I attached the manual here -- I hope this helps!
Thanks a lot. I found the LEMO connector wiring scheme. According to the manual- should I apply the voltage between DC\PULSE and CAL\MEAS pins only, as said in table 3 in manual or in addition apply +15V to "15V" pin, according to table 2 in manual? I attach the LEMO connector scheme I got.