Discussion Forums are temporarily in read only mode. All forums are visible but posting is not possible. Please check back shortly.

Thread: Spectrasys Antenna Path


Permlink Replies: 2 - Pages: 1 - Last Post: May 2, 2012 1:55 AM Last Post By: rango
rango

Posts: 3
Registered: 04/24/12
Spectrasys Antenna Path
Posted: Apr 24, 2012 2:42 PM
Click to report abuse...   Click to reply to this thread Reply
Can anyone tell me in the spectrasys tool bar there is a Antenna Path module. There is a term in the properties of that module name "DISTANCE". Is that distance is in meters?

Regards
wrivas

Posts: 141
Registered: 06/08/09
Re: Spectrasys Antenna Path
Posted: Apr 24, 2012 3:42 PM   in response to: rango in response to: rango
Click to report abuse...   Click to reply to this thread Reply
The Genesys manual has the following information:

The units for distance is arbitrary. However 'Lossa' is the rate of the attenuation for the same distance unit. Therefore, if the distance is in miles then 'Lossa' must be the attenuation in dB per mile.
rango

Posts: 3
Registered: 04/24/12
Re: Spectrasys Antenna Path
Posted: May 2, 2012 1:54 AM   in response to: wrivas in response to: wrivas
Click to report abuse...   Click to reply to this thread Reply
can you plz give(attach) me the Agilent Genesys Manual that really help me to understand the basic terms used in the software.

Regards

Edited by: rango on May 2, 2012 1:54 AM

Point your RSS reader here for a feed of the latest messages in all forums