Thread: U3606A emission


Permlink Replies: 1 - Pages: 1 - Last Post: Jun 22, 2012 10:11 PM Last Post By: thong-lin_tan
dave_f

Posts: 1
Registered: 07/06/11
U3606A emission
Posted: Jul 6, 2011 3:17 AM
Click to report abuse...   Click to reply to this thread Reply
We purchased a U3606A for use in a test setup. The data taken contained spurious signals, which was tracked down to be coming from the U3606A. A cross-check confirmed that our E3646A is not emitting anything like this, and the E3620As we have are some of the quietest supplies we have.

I've included a scope trace taken at the force output on the front panel, unloaded. A lot of this is also on the measurement input. Is this normal, or is the unit defective?
thong-lin_tan

Posts: 17
Registered: 11/11/08
Re: U3606A emission
Posted: Jun 22, 2012 10:11 PM   in response to: dave_f in response to: dave_f
Click to report abuse...   Click to reply to this thread Reply
Hi Dave,

If you need technical support for your highlighted U3606A unit issue below, please contact your nearest Agilent Service Center or submit your technical support request via Agilent Technical Support link below. I hope this is help.

https://www.home.agilent.com/agilent/editorial.jspx?cc=US&lc=eng&ckey=1536179-1-eng&nid=-536902435.899262&id=1536179-1-eng

Regards,
ThongLin


Point your RSS reader here for a feed of the latest messages in all forums