Thread: Low speed option and SPI crash situation

Reply to this Thread Reply to this Thread Search Forum Search Forum Back to Thread List Back to Thread List

Permlink Replies: 1 - Pages: 1 - Last Post: Oct 30, 2009 5:01 PM Last Post By: ko2054 Threads: [ Previous | Next ]
daniele.banfi

Posts: 10
Registered: 10/17/09
Low speed option and SPI crash situation
Posted: Oct 30, 2009 4:11 AM
Click to report abuse...   Click to reply to this thread Reply
Hello everyone

I've a DSO8064A scope with lowspeed options and 4Mpts. Today I've try to make a SPI measurement with decode enable, using all 4 channels.

If I use 3 channels (clock, CS and MOSI) the system working fine and the decode is correct; when I try to use the last channel (MISO), set the decode option, after a regular trigger signal the scope go in error (crash) situation and show the dialog message:

Error in agscope.exe ver: 5.71.00 ....
offset 001A84C0

Same with software 5.50.0001

Any idea ?

Daniele Banfi
ko2054

Posts: 76
Registered: 06/06/07
Re: Low speed option and SPI crash situation
Posted: Oct 30, 2009 5:01 PM   in response to: daniele.banfi in response to: daniele.banfi
Click to report abuse...   Click to reply to this thread Reply
Hello Daniele, I am researching an answer for you. Sorry for the delay.
Pages: 1
Back to Thread List Back to Thread List
Threads: [ Previous | Next ]

Point your RSS reader here for a feed of the latest messages in all forums