Discussion Forums are temporarily in read only mode. All forums are visible but posting is not possible. Please check back shortly.

Thread: U2353A overflow


Permlink Replies: 1 - Pages: 1 - Last Post: Mar 29, 2012 8:11 PM Last Post By: hingyeho Threads: [ Previous | Next ]
leoeltipo

Posts: 1
Registered: 02/01/12
U2353A overflow
Posted: Feb 1, 2012 8:22 AM
Click to report abuse...   Click to reply to this thread Reply
Hi all. I am a new user of the forum. I am having some troubles when using the U2353A DAQ with Matlab. My script seems to work fine the first time it is executed, data is properly acquired and it is correct. If I repeat the acquisition, the data starts approaching the input limit (-10 in this case). The only solution I found is issuing a "hard reset" (I actually have to unplug the device and re-connect).

Thank you very much for your help.

Leandro
hingyeho

Posts: 3
Registered: 09/16/09
Re: U2353A overflow
Posted: Mar 29, 2012 8:11 PM   in response to: leoeltipo in response to: leoeltipo
Click to report abuse...   Click to reply to this thread Reply
Most probably you are using too high of a sampling rate. Try reducing it.

Total sampling rate/number of channels activated = Each channel's supported sampling rate.

Point your RSS reader here for a feed of the latest messages in all forums